1. Get belt material that is about one inch longer than the distance around both pulleys. 2. With a sharp pencil, mark the distance around the pulleys on the dull part of the belt from one end to the other. (the image shows the leather strip’s length – the distance around both pulleys – and […]
Here is the process for fitting your repair parts into the Columbia large floating aluminum reproducer, like the one shown here. The internal diameter (diaphragm size) is 1-3/4 inches (~4.5 cm). This process also applies to the smaller Columbia aluminum floating reproducers. What You Will Need Bunsen burner Denatured alcohol Matches Round toothpicks Small, fresh […]
18
Jan
Jan
In the picture above, location 3 is where the diamond stylus is located. First and foremost: only Edison Diamond Disc records can be played with this reproducer. If the entire weight (2) does not easily move left/right, then the screw on top of the hinge block (1) must be loosened (difficult to do, but necessary) […]
21
Nov
Nov
Here is a view of all the parts that a Victor Exhibition reproducer has. When overhauling such a reproducer, it is wise to replace the two white gaskets since the original ones are most likely stiff and cracked. If parts are needed, stock numbers are provided so you can look up and order through our […]
For this project, it will be beneficial to have an assistant. You can find grille cloth in our store. Clean the back of the grille, removing old cloth and any strips of wood that can be re-positioned afterward. The new cloth should be over-sized compared to the grille. Decide on the side of cloth you […]
One question that comes up from time to time is how to apply turntable felt. I’ve put together this article detailing the process I’ve used for decades. An assistant would be helpful but is not required. We have felt available in various sizes for purchase in our store. Thoroughly remove the old felt from the […]